WattShape

Your house already has a battery.

WattShape reads tomorrow's spot prices and tonight's solar forecast, then decides every 15-minute interval: charge, discharge, run the heat pump, feed the EV. One brain for the whole site — inside Home Assistant, on-premises, no cloud required.

How it works

Install via HACS Home Assistant

One custom repository, one restart. The setup wizard binds your inverter, battery, meter, EV charger and heat pump — no rewiring, no extra hardware.

It learns your site

Load forecast, PV correction, battery wear, tariff model — built from your own measurements, refined every day. A dynamic program then optimizes every quarter-hour across the whole horizon.

It runs. You watch the ledger.

Every decision is priced against what a dumb self-consumption system would have done — the savings are written down, interval by interval. If anything loses connectivity, WattShape fails safe to plain self-use.

Does the boring parts

Battery arbitrage

Charges into price valleys and PV surplus, discharges into peaks — wear-aware, tariff-aware.

Per-phase balancing

On multi-inverter sites it can charge one phase while discharging another, against per-phase metering.

EV smart charging

Trip-aware plans: the car is full when you need it, charged when power was cheapest.

Heat-pump dispatch

Thermal mass is a battery you already own — pre-heats into cheap and sunny hours.

15-min spot prices

Quarter-hour products, peak shaving and tariff models built for the Czech and EU markets.

Fleet-ready

Commercial sites and portfolios: many locations, one operating picture, per-site autonomy.

Get it

WattShape is in active beta with real sites running. Want it on your PV, battery or heat pump — or across a commercial fleet? Tell us about your setup.

Join the beta

Beyond one house

Energy doesn't stop at the fence. For energy communities — shared PV, common settlement, member management — we're building Proud Energy, a community energy portal.