WattShape reads tomorrow's spot prices and tonight's solar forecast, then decides every 15-minute interval: charge, discharge, run the heat pump, feed the EV. One brain for the whole site — inside Home Assistant, on-premises, no cloud required.
One custom repository, one restart. The setup wizard binds your inverter, battery, meter, EV charger and heat pump — no rewiring, no extra hardware.
Load forecast, PV correction, battery wear, tariff model — built from your own measurements, refined every day. A dynamic program then optimizes every quarter-hour across the whole horizon.
Every decision is priced against what a dumb self-consumption system would have done — the savings are written down, interval by interval. If anything loses connectivity, WattShape fails safe to plain self-use.
Charges into price valleys and PV surplus, discharges into peaks — wear-aware, tariff-aware.
On multi-inverter sites it can charge one phase while discharging another, against per-phase metering.
Trip-aware plans: the car is full when you need it, charged when power was cheapest.
Thermal mass is a battery you already own — pre-heats into cheap and sunny hours.
Quarter-hour products, peak shaving and tariff models built for the Czech and EU markets.
Commercial sites and portfolios: many locations, one operating picture, per-site autonomy.
WattShape is in active beta with real sites running. Want it on your PV, battery or heat pump — or across a commercial fleet? Tell us about your setup.
Join the betaWattShape runs fully on-premises by default — that's not going away. Sites that opt in can be monitored and remotely controlled through Proud Energy, our community energy portal: one operating picture and dispatch across a whole fleet — for installers, portfolios and energy communities.
Energy doesn't stop at the fence — shared PV, common settlement and member management live in the portal.